This is a BAD-MAMMA-JAMMA Power Custom Trigger...

This is a BAD-MAMMA-JAMMA

Power Custom Trigger Pin Latch
Tapco Double Hook Trigger
Ace Side Folder Stock/Friction Hinge/Internal Block
Ace Rear Sling Swivel
Magpul Front Sling Atachment Point
Black SKS Sling with Paracord Backups (Silent Sling)
INFORCE Weapons Light
Magpul AFG
U.S. Palm Pistol Grip
Black 30 Round Bulgarian Waffle Mags (With Paracord Pulls)
YHM 7.62 Q.D. Stainless Sound Suppressor ( I use this one suppressor on 12 different guns)
M.I./U.S. Palm X Rail System/with Co-Witnessing Sight Capibilities
Burris Fastfire II Micro Red Dot
YHM Flash Hider Q.D. Sound Suppressor Mount
YHM Thread Protector (Not Shown)
Ergo Black Rail Covers
Vented Gas Tube (For Suppressor Use)
Chop Ace Stock to 6.75” (I like a short L.O.P)
Install Internal Block/Flipped Hinge for Right Side Folder (Easier to deploy the stock when hanging off chest when folded)
Turned Up RH Charging Handle to clear RH Folder
Recut and Polished Feed Ramp (Some AK’s WONT feed S.P./H.P. Ammo, or HEAVY Subsonic Projectiles)
Rear Sight Dehorned
Removed Barrel/Turned Barrel down to .550/Cut Barrel to 13.5” (Makes the gun SUPER handy, especially with the Suppressor)
Recrown/Rethread/Relocate and Pin FSB/Retime Muzzle Device/Pin YHM
Reinstalled Barrel Assembly (Overall Length 17.0” with Pinned YHM Device)
Weld Old FSB Muzzle Retainer Pin Holes (Just commetic since the Retainer wasnt needed for the YHM Flash Hider)
Custom Safety Tab with Bolt Hold Open (Can Manipulate the Safety with the Trigger Finger)
Tuned and Tensioned Safety/Welded Tab to eliminate Trigger Slop when the Safety is engaged
Dehorned/Refinished Gun Black Duracoat (Wont cut you up like many AK’s do when you run them hard)
Polished Bolt Carrier/FCG Contact Surfaces (Gun cycles easier on Light Loads/Subsonic Loads and Charges easier)
Left Side Charging Handle
Rounded Trigger Surface (Smoother on the Trigger Finger)
Trigger Job